CNC Heavy Duty Lathes

Flat Bed CNC Lathes

This entirely new design places the emphasis firmly on multi-performance, safety, low noise, advance productivity and easier operation.

AC-1800 Series AC-2100/2500 Series

AC-2600/3000/3300 Series AC-5100 Series

Standard Equipment

	FAGOR Control is standard, but ANILAM, FANUC & SIEMENS available on request.
	Spindle auto speed shifiting (3steps) and CNC controlling.
	All castings are made from high tensile Meehanite cast iron which are annealed treated to eliminate internal residual stress.
	Wide bed and box constructed, bed ways are high frequency heat treated, precision ground etc., to provide stability at high speed running or deep cut.
	Spindle and gear are made of CR-MO ally steel which are carburizing and precisely ground.
	Lubricating and oil bathed combined in headstock which can prolong service life.
	Three point support on the spindle with two taper roller bearings and one roller bearing to assure accuracy and rigidity.
	AC main drive spindle motor.
	High precision ball screw.
	Imperial and metric threading.
	Easy manual turning of radial, chamfering, taper, facing and grooving.
	Tool radius and geometry compensation.
	Internal digital readout.
	Constant surface speed for model with infinitve variable speed.
	Integrated PLC
	8 Bit Bus, 32k RAM
	Serial port (RS-232 interface)
	Teach-in mode.
	Semiautomatic, automatic (cycle) and part program modes.
	Automatic acceleration/deceleration.
	Rapid travels.
	Self diagnostic routines.
	Automatic home searching.
	Program input RS-232 or floppy disk (option)
	1.44mb floppy drive (option)
	External DNC communication software.

Specifications

Note: We have the right to modify the specifications or designs. Subject to change without prior notice.